MacDon 963 Harvest Header - Manual (Page 22)

21
HEADER OPERATION
Operating Variables
To adjust delivery opening width (continued)
2. Remove screws from draper connector slat.
3. Use the following chart to position draper connector tubes at the appropriate rows of holes and position
rollers at center opening for the desired application.
CONNECTION
CENTER DELIVERY
OPENING WIDTH (W)
(between rollers)
LEG TO
ROLLER EDGE
(DIM. X)
DESIGNATED APPLICATION
and COMMENTS
Row A to Row F (both drapers) 33.9" (860 mm) 22.4" (568 mm) Opening for combine models: Case 60 & 66
Series, NH CR 920/940/960
Row A to Row G (both drapers) 39.7" (1010 mm) 19.4" (493 mm) Opening for Gleaner combines
Row A to Row E (both drapers) 41.7" (1060 mm) 18.4" (468 mm) Opening for Case 77, 80 & 88 Series,
NH-CR 970/980, Challenger 660 and MF
9690
Row A to Row H (both drapers) 49.6" (1260 mm) 14.4" (365 mm) Opening for Lexion 450, 460R, 470, 470R,
475, 560, 560R, 570R, 575R, 580, 580R &
585R Combines
Row J to Row D (both drapers) 53.5" (1360 mm) 12.4" (315 mm) Opening for combine models: JD STS,
CTS, 9500, 9510, NH CX, Challenger 670
and MF 9790
Row A to Row C (both drapers) 59.5" (1510 mm) 9.6" (243 mm) Opening for combine models: JD 9600,
9610, 9650 and Lexion 460, 465, 480,
480R, 485 & 485R Combines
Row A to Row B (both drapers) 65.8" (1670 mm) 6.4" (163 mm) Maximum opening for windrowing