MacDon 963 Harvest Header - Manual (Page 67)

66
UNLOADING & ASSEMBLY
INSTALL GAUGE WHEEL / TRANSPORT OPTION
(continued)
7. Attach the three gauge wheels to hubs. Torque
wheel bolts to 80 to 90 ft.lbs. (110 to 120 N ⋅ m).
8. Install pins (B) in stand position as shown.
(Both supports.)
9. Left wheel caster is shipped in field position,
with wheel outboard of support.
NOTE: Left wheel caster can be installed at left or
right side of wheel support. This positions the left
wheel inboard or outboard of wheel support as
desired. If caster is being moved to opposite side,
note that U-shaped loop (G) on caster must point
to middle of wheel support. Access to loop (G) is
through slot (H).
10. Lower header onto gauge wheels and 6" (150
mm) blocks under cutterbar. Remove shipping
stands.
11. Check tire pressure. Inflate to 42 to 46 psi (290
to 315 kPa).
12. Assemble light package to header as follows:
a. Open left hand drive shield and route header
section of wiring harness through inside of
frame tube to right endsheet.
NOTE: The end of the harness with the 6-way
connector goes to the right endsheet.
b. Route the other end of this harness (with 4-way
connector) through slot in left endsheet (see [J]
top photo, next page), along driveline shield to
left gauge wheel leg, down and through tube
which secures wheel support to header leg.
Leaving 22 in. (560 mm) of harness protruding
from inboard end of tube (A), use the large
plastic ties (E) to secure the harness to
driveline shield. For 30 ft. headers, also use
one small plastic tie (F) to secure harness at
flange on header leg.
LEFT WHEEL CASTER:
ALTERNATE POSITIONS
LEG PINS IN STAND POSITION
B
HARNESS ROUTING - LEFT WHEEL SUPPORT
A
F
E