MacDon 963 Harvest Header - Manual (Page 33)

32
TRANSPORT
Gauge Wheels / Transport Option
CONVERTING FROM FIELD POSITION
TO TRANSPORT
At L/H end (continued):
11. Slide bar (C) to caster side of support. (Bar
stops caster from sliding up.)
12. Move pin (B) at left wheel support from
conversion position to transport position
(through header leg as shown).
13. Disengage header lift cylinder stops and slowly
lower header until wheels are on the ground.
Block the tires to prevent header rolling and to
ensure left wheel remains under header,
tracking approximately parallel to cutterbar.
14. At right end, check that cutterbar support
contacts guards.
15. Detach header from power unit. See Windrower
Tractor or Combine Adapter Operator's Manual.
Be sure reel is fully down and all hydraulic lines
are properly disconnected and stored. If
combine adapter is to remain with the header,
ensure float lock-outs are engaged.
16. Remove hitch pole from storage on frame tube
and place hitch over left wheel caster. Position
hitch against stop welded on caster and install
pin (A) (removed in step 9) with hairpin.
IMPORTANT: Be sure pin is inserted far
enough to allow pin handle to hang down as
shown.
17. Attach wiring harness (H) at left caster.
LEFT WHEEL - TRANSPORT POSITION
C
B
ATTACH HITCH AND WIRING HARNESS
A
H