MacDon 963 Harvest Header - Manual (Page 26)

25
HEADER OPERATION
Operating Variables
DIVIDER ANGLE
The dividers can be angled in or out to provide
proper separation and clean entry in a variety of
crops. Divider gather is factory set at
approximately 1.5 inches (40 mm). In tangled
crops like canola, it may be necessary to reduce
gather.
To adjust angle, loosen hardware (A), position
divider and tighten hardware.
NOTE: On left side, ensure that front hinge pin of
side shield remains covered.
Shut Down Procedure
CAUTION: Before leaving operator's seat for any reason:
1. Park on level ground if possible.
2. Lower the header and reel fully.
3. Place all controls in NEUTRAL or PARK.
4. Disengage header drive.
5. Engage the park brake.
6. Stop engine and remove key from ignition.
7. Wait for all movement to stop.
DIVIDER ANGLE ADJUSTMENT
A