MacDon 963 Harvest Header - Manual (Page 66)

65
UNLOADING & ASSEMBLY
INSTALL GAUGE WHEEL / TRANSPORT OPTION
(continued)
5. Install 1/2 inch hex head bolt (H) and locknut
(removed above), attaching dual wheel beam
to right wheel support in field position.
NOTE: The pivot shaft on the wheel beam can
be installed at right side (A) or left side (B) of
wheel support. This allows field positioning of
the beam either "inboard" (towards center of
header) or "outboard" (towards end of header),
as desired. See chart for recommended
position depending on power unit.
6. Install brace anchor (G) under cutterbar at the
9th guard bolt from center of R/H header leg,
replacing standard bolt with 1-3/4" long.
NOTE: If a sickle hold-down or deck support is
installed at 9th bolt, relocate hold-down or
support to an adjacent location.
POWER UNIT
9000/4900/2900
WINDROWER 9030 TRACTOR:
CENTER MOUNT
ADAPTER 9030 TRACTOR:
OFFSET MOUNT
ADAPTER
COMBINE
H
E
A
D
E
R
PIVOT
SHAFT
POSITION BEAM IN
FIELD
POSITION PIVOT
SHAFT
POSITION BEAM IN
FIELD
POSITION PIVOT
SHAFT
POSITION BEAM IN
FIELD
POSITION PIVOT
SHAFT
POSITION BEAM IN
FIELD
POSITION
30' B OUT A IN A IN B OUT
36' B
or A
OUT
or IN
B
or A
OUT
or IN
B
or A
OUT
or IN
B
or A
OUT
or IN
INSTALL BRACE ANCHOR AT CUTTERBAR
ATTACH RIGHT WHEEL BEAM