Retsch PM 200 - Manual (Page 30)


Retsch GmbH
30
Interval
00:01 to 59:59
Minutes:Seconds
Reverse rotation cannot be set until an interval is set.
Reverse rotation
YES
NO
The PM100/200 is started at the pre-selected grinding time, speed and reverse rotation. The
machine rotates with the specified interval time in one direction, runs down and then starts
immediately after coming to a stand still, without interval break, in the other direction.
Interval break
BACK
00:01 to 59:59
Minutes:Seconds
The interval break can be set here from 00:01 to 59:59
Minutes:Seconds.
An interval break cannot be set until an interval is set.
The PM100/200 is started at the pre-selected grinding time, speed, reverse rotation and
specified interval break. The machine rotates with the specified interval time in one direction, runs
down, after coming to a stand still the previously specified interval break is displayed in the
interval and counted down to 00:00.
Once the interval break has expired, the machine starts in the other direction.
Program mode
Store parameters
All previously specified parameters, such as grinding
time, speed, interval and pause can be stored to memory
here.
 Set the desired parameters.
 In the menu, change to "Program mode", press the setting button and confirm "Store
parameters" again, the menu shows "Grinding program" and the storage place number on
the right.
 Turn the setting button to the right until you find a grinding program with free storage
places or one which you want to overwrite.
 Press the setting button to reserve the selected storage place.
 You can now choose between "Save parameters?" or "Cancel".
 You are then returned to the "Program mode" level.
Program mode
Edit program
All previously specified parameters, such as grinding time,
speed, interval and pause can be edited here.
It is likewise possible to enter new parameters.
 Select "Program mode", "Edit program“ and confirm with the setting button, the display
shows grinding program again with the storage place number.
 Select the "Grinding program" to be edited by pressing the setting button, only the storage
place figures are inverted, change the grinding program by turning the setting button.
 Confirm the grinding program to be edited by pressing the button, the parameters can now
be edited.
 You can subsequently choose between "Save parameters" or "Cancel"
 You are then returned to the program mode level.
Program mode
Delete program All previously stored parameters can be deleted here.
 Select "Program mode", press the setting button, and confirm "Delete program“ again.
 Select the grinding program to be deleted by turning the setting button and confirm by
pressing.
 You can now choose between "Delete program" or "Cancel"
 You are then returned to the program mode level.