Retsch PM 200 - Manual (Page 35)


Retsch GmbH
35
F13 to F26
F13
The display shows
F14
Fault speed sensor
Service required!
The display shows The display shows
F15 F16
Problem in the Motor has overheated
safety circuit of the No START possible
frequency converter
Let motor cool down
Service required!
The display shows The display shows
F17 F18
Motor has overheated Problem in the
Was switched off safety circuit of
Let motor cool down the transformer
Continue with STOP Service required!
F19 F20
The display shows
Overload
110%
F21
The display shows The display shows
Overload 120 % F22
Due to overload
Please reduce to ??? rpm speed automatically
reduced to ??? rpm
The display shows The display shows
F23 F24
Problem in the Balance control is
safety circuit of out of tolerance
balance control Please rebalance
Service required!
F25
The display shows The display shows
F26
Parameters OK?
Frequency converter
START = Machine START has overheated
STOP = Check No START possible
Allow to cool down