Retsch PM 200 - Manual (Page 6)


Retsch GmbH
6
Safety directives summarised, part 1
Safety instructions
We reject herewith any and all claims relating to personal injury or material damage that result from the
failure to comply with the following safety instructions .
Intended use
Do not make any modifications to the machine and only use Retsch approved spares and accessories.
The conformity to the European guidelines declared by Retsch otherwise loses its validity.
It furthermore leads to the loss of all warranty claims.
Packaging
Please retain the packaging for the duration of the warranty since, in case of complaint, returning in unsuitable packaging
can jeopardize your warranty claims.
Transport
During transportation, do not subject the PM100/PM200 to impacts, jolts or vibrations. The electronic and mechanical
components could otherwise be damaged.
Temperature fluctuations
In case of wide temperature fluctuations (during shipment by air, for instance), protect the PM100/PM200 from con-
densation. The electronic components could otherwise be damaged.
Scope of supply
If the shipment is incomplete and / or has suffered transport damage, you must notify the forwarder and Retsch GmbH
immediately (within 24 hours). Under certain circumstances, claims lodged at a later date may not be considered valid.
Ambient temperature :
When the ambient temperature exceeds or falls below that specified, the electronic and mechanical components may be
damaged, and performance data changed to an unknown extent.
Air humidity :
At a higher air humidity, electronic and mechanical components may be damaged, and performance data changed to an
unknown extent.
Electrical connection / Connecting the power
Failure to observe the values on the data plate can cause damage to electronic and mechanical components.
Inserting and clamping grinding bowls in the PM100
Only use grinding bowls of type "C".
This, in conjunction with the grinding bowl fixture, is a safety component.
Working with old or third-party grinding bowls in the PM100/PM200 risks unforeseeable hazards.
Never allow threaded spindle 3 to lie loose in the grinding bowl fixture without the grinding bowls clamped in.
Danger of being hurled out!
Always ensure that the red sleeve has latched in properly. Otherwise the grinding bowl is not securely clamped.
Danger of being hurled out!
Inserting and clamping grinding bowls in the PM200
Only use grinding bowl of the type "C".
This, in conjunction with the grinding bowl fixture, is a safety component.
Working with old or third-party grinding bowls in the PM100/PM200 risks unforeseeable hazards.
Never allow threaded spindle 4 to lie loose in the grinding bowl fixture without the grinding bowls clamped in.
Danger of being hurled out!
Always ensure that the red sleeve has latched in properly. Otherwise the grinding bowl is not securely clamped.
Danger of being hurled out!
Only use grinding bowls of type "C" and only up to a nominal volume of 125ml
The PM200 will otherwise be overloaded and mechanical components could be damaged!
Only ever use 2 grinding bowls with the same gross weight.
Otherwise the PM200 generates unpleasant vibrations!