Retsch PM GrindControl - Manual (Page 12)

The First Start
12
Fig. 2: Enter into the MAC address field.
You will find the MAC address on the cover page of your operating manual:
Fig. 3: MAC address
After 15 minutes without assignment to a measurement task, the wireless
grinding jar cover switches off. If the status indicator lamp is not glowing red
any longer, take out one of the batteries and then put it back in again.
8. Click on the button Add measurement system..
Once the system corresponding to the MAC address has been found,
9. confirm with the OK button.
The status indicator lamp now glows green.
The System Information program window is displayed.
10. In the Name field, enter a name for the wireless grinding jar cover.
Fig. 4: Name field
11. After clicking on the Accept button,
12. you can end the procedure by clicking on the Close button.
The changed name is the name that is stored in the measurement system. On
connecting the next time, the measurement system will identify itself with this new
name.
13. Double-click to open the active system and click on the Assign field
Fig. 5: Assign active system to the measurement.