Retsch RS 200 - Manual (Page 15)

15.11.2006

Retsch GmbH
15
Doc. Nr. D 98.725.9998
Emergency unlocking
A key for the machine is included in the delivery, with which
the RS200 can be manually opened if there is a power failure.
(Fig. 9 Emergency unlocking)
 (I) Insert the (S) key into the (O) opening on the
right-hand side.
 (II) To unlock the gear, the key must be pushed in
further with some degree of force. While pushing the
key in, turn it in a clockwise direction as far as it will
go.
The cover can now be opened.
The emergency unlocking device must never be operated
when the machine is running – only when the machine is at a
standstill and is disconnected from the mains supply.
Danger of injury through unbraked, after-running of the
drive.
Insertion and clamping of the milling set of the
RS200
Wolframcarbid Tungsten carbide (WC) grinding sets
(01.462.0177 • 01.462.0265 • 01.462.0264)
NOTE: RS 200: Operate WC grinding sets only at speeds
≤1200 min-1.
RS 100 max. speed ok.
Do not use the grinding jar if it has 4 identical 13-mm-
diameter boreholes on the bottom.
These grinding jars may only be used in RS200 devices that
do not have a change index after the serial number. This
means that if a change index (e.g. xxxxxxxxx-F) is specified
behind your device’s serial number, you may not use the
older grinding jar described in the above.
Older grinding jars with 4 identical boreholes on the bottom
(13mm) can be reworked free of charge.
Fig. 9 Emergency unlocking
Abb.7 Bedienfeld
RS 200 Max. Speed
≤ 1200 min -1
RS 100 Max. Speed
ok