Retsch RS 200 - Manual (Page 6)

15.11.2006

Retsch GmbH
6
Doc. Nr. D 98.725.9998
Safety instructions – summarised, part 2
Safety instructions when starting the RS200
Before starting the machine ensure that the milling set is clamped.
The milling set can be ejected. Danger of injury and damage to the equipment.
Tips for fine milling
When using easily flammable materials it is essential to observe the section „Wet milling of easily flammable materials”.
Danger of explosion.
Guide values for the material quantity
If the filling level of the milling set is too high or too low the milling result will be impaired and this can cause damage
(increased abrasion) to the milling set.
Please take necessary measures, depending on the dangerous nature of your milling material, to avoid danger to persons.
When removing and opening hot milling cups it is essential to wear protective gloves.
Danger of burning the hands.
Cleaning the milling cups
Do not subject milling cups with ceramic inserts to rapidly changing temperature differences when rinsing.
The ceramic units can crack through sudden temperature changes.
Wet milling of easily flammable materials.
Before using easily flammable materials as millling auxiliary agents it is essential to specify in writing the
explosion protection documentation of the EC-directive, according to article 118 and 118a, as laid down in
directive 89/391/EEC.
Cleaning
Do not clean the RS200 with running water.
Danger to life through current surge.
Use only a cloth moistened with water.
Solvents are not permitted.
Maintenance
Easy running of roller 1 on the closing pin is necessary for reliable closing via the automatic closing mechanism of the RS200.
Wearing parts
These operating instructions do not include repair instructions. For your own safety repairs should be carried out only by
Retsch GmbH, an authorised agent or service technicians.