Retsch RS 200 - Manual (Page 22)

15.11.2006

Retsch GmbH
22
Doc. Nr. D 98.725.9998
Speed with agate 700 rpm
If no milling cup, or a milling cup with agate lining, is clamped, the speed is limited to 700 rpm and cannot be
changed.
Figure 1 Figure 2
If no milling cup, or a milling cup with agate lining, is
clamped the display in fig. 1 appears.
After confirmation with the START button the menu (fig. 2)
appears in the display and all parameters except speed can
be changed.
The RS200 is started with the preselected milling time.
Programme mode
Take over parameters
Here all the previously set parameters, such as milling
time, speed, interval and pause, can be stored in a store.
 Set the required parameter.
 Change to „Programme mode“ in the menu, press the setting knob and confirm „Take over
parameters” again. The menu shows „Milling programme“ and on the right the storage
location number.
 Turn the setting knob to the right until you have found a milling programme with empty
storage locations, or one which you wish to overwrite.
 By pressing the setting knob you can reserve the selected storage location.
 You can now choose between „Store parameter?” or “Cancel”.
 You will then be returned again into the “Programme mode” level.
Programme mode
Change programme
Here all previously stored parameters, such as milling time,
speed, interval and pause, can be changed.
It is also possible to enter new parameters.
Select „Programme mode“, „Change programme“ and confirm with the setting knob. The
display shows the milling programme with storage location number again.
 To select the „Milling programme“ to be changed press the setting knob; only the storage
location numbers are inverse – the milling programme is changed by turning the setting
knob.
 Confirm the milling programme to be changed by pressing; you can now change the
parameters.
 After this you can „Store (the changed) parameters” or “Cancel”.
 You will then be returned again to the “Programme mode” level.
Programme mode
Delete programme Here all the previously stored parameters can be deleted.
 Select „Programme mode“, press the setting knob and confirm „Delete programme” again.
 Select the milling programme to be deleted by turning the setting knob, and confirm by
pressing.
 You can now “Delete programme” or “Cancel”.
 You will then be returned again to the programme mode level