Retsch RS 200 - Manual (Page 16)

15.11.2006

Retsch GmbH
16
Doc. Nr. D 98.725.9998
In the RS200 a Retsch milling set of volumes 50 / 100 / 250
ml and materials special steel / agate / tungsten carbide can
be used.
Never start the RS200 without the clamped milling set.
Mechanical components can become damaged.
Preparation of the milling process

Fit the milling cup with a disc and a ring. Two rings can
also be inserted, depending on the milling set.
Position the rings and disc as shown in the
illustration opposite.
(Fig. 10 Positioning the ring and disc)
 The material to be milled is filled into the space R
between the milling cup wall and the first ring. For an
optimum milling result do not fill any material into the
space between the inner ring and disc.
(Fig. 11 Filling volume of milling cup)

Remove any residues of the milling material adhering to
the milling cup (e.g. with a brush).

Close the milling cup with the lid, not forgetting the seal.
 Engage the milling set in the locking bolt B of the holding
device by turning slightly.
(Fig. 12 Locking bolt)

The milling set is clamped with the eccentric lever S

You can then close the hood and start the RS200
(Fig. 13 Eccentric lever)
Please take necessary measures, depending on the
dangerous nature of your milling material, to avoid danger
to persons.
S
B
R
Fig. 10 Positioning ring and disc
Abb.7 Bedienfeld
Abb.10 Platzierung Ring und
Scheibe
Abb.7 Bedienfeld
Fig.11 Filling volume of milling cup
Fig. 12 Locking bolt
Fig.13 Eccentric lever