Retsch RS 200 - Manual (Page 23)

15.11.2006

Retsch GmbH
23
Doc. Nr. D 98.725.9998
Starting time
Start in xxh xxm
Cancel Starting can be preselected here in steps of 01 to 99 hrs or
01 to 60 min.
The RS200 is started with the preselected milling time and speed after the set starting time has
elapsed.
Ensure that the milling cups have been clamped properly before
you start the machine unattended.
Even though starting without the lid closed is not possible, make
sure that the lid is closed before you start the machine
unattended.
You can interrupt running of the starting time at any time with the STOP button and with the main
switch on the rear side of the unit. You then have to reprogramme the starting time.
Opening automatic
MENU SETTINGS OPENING AUTOMATIC
Here you can preselect whether the milling chamber lid is automatically lifted at the end of milling, or is to be
opened only by pressing the knob. If the function is switched off the
pictogram appears in the display to confirm this.
Fault signals through incorrect operation can be supported acoustically by a warning sound.
With the function switched off the corresponding pictogram appears
Service
MENU SETTINGS SERVICE
The service menu is divided into four sub-menus:
 SERVICE INSTRUCTIONS
Service instructions are filed here in the form of a checklist which is intended to facilitate effective,
regular service and to improve the operating state of the machine. See also the section General /
Maintenance.
 SERVICE INTERVAL
An individual service interval can be seet here, according to the environment of the machine. After this
time the operator is required to have the machine serviced. The time to be set is related to the total
sum of milling times (times between START and STOP). A time between 1 – 99 hrs can be set. If the
environmental conditions are rough we recommend that the works preset time is reduced.
 OPERATING HOURS
The milling hours are counted, i.e. the total sum of the times between START and STOP. These times
cannot be manipulated.
 OPERATING SOFTWARE
The operating software version can be interrogated and, if necessary, updated. When required please
contact your Retsch distributor.
If you have accidentally got into the menu and jumping back into the previous menu is not possible,
switch off the unit at the main switch and restart.
Warning sound
MENU SETTINGS WARING SOUND