Retsch PT 200 - Manual (Page 25)

Operating the machine
25
Fig. 15: Rear view of the DR100
NOTE
PT 100 and DR100 must be suitable for the same electrical mains supply, (see
type plate).
Failure to comply with the ratings on the type plate on the PT 100 and DR100 can
cause damage to electronic and mechanical components.
• Connect the DR100 to the mains power supply using the C13 panel-
mounted male connector (inlet) (DZ).
• Set the switch (DS) on the back of the DR100 to “Standard”.
Fig. 5: Setting the DR100 feeding speed
• Set the feeding speed regulator (DK) on the DR100 to the required position
(depending on the material to be divided).
• Fill the DR100 feed hopper.
• Adjust the slot width between the feed hopper outlet and the push-fit chute base
(feed level).
The setting of the gap between the push-fit chute and the feed hopper depends on
the maximum particle size of the feed material. It should be about 3 times as large
as the max. particle size.
• Press the ON/OFF switch (DN) on the DR100 .
• Turn on the sample divider and start it.
The DR100 does not start until the sample divider has reached the nominal speed.
The DR100 switches off automatically when the nominal speed of the sample
divider varies too much or drops. If this fluctuation lasts only for a short time (<5s),
the DR100 switches on again once the nominal speed has been reached again
and the feeding process is continued. As soon as you stop the sample divider, the
DR100 stops too and the sample is not fed.
Pos : 6.33 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Pr obensc hlitz Eins tell ung @ 3\mod_1302780321109_9.doc @ 25105 @ 2 @ 1
5.14 Setting the sample slot width
Pos : 6.34 /00010 Bedi enungsanleitung en Kapitels ammlungen/PT200 (2011)/0015 PT 200 Bedienung/1555 PT200 M odul Probensc hlitz Ein stellung @ 3\mod_1301576384542_9.doc @ 24514 @ @ 1
SW
DS
DK
DN
DZ