6 cleaning and service, 7 fault messages, Cleaning and service – Retsch PT 200 User Manual
Page 28: Warning, Notice
Cleaning and service
28
The fuses in the inside of the device may only be replaced by Customer Service.
Pos : 7.1 /00005 Übersc hriften/1. Übersc hriften/1 Rei nigung und Wartung @ 0\mod_1231167007723_9.doc @ 5450 @ @ 1
6 Cleaning and service
Pos : 7.2 /00004 War nhi nweis e/W0003 WARN UNG R einig ung Stromstoß neu @ 1\mod_1236239978437_9.doc @ 7686 @ @ 1
WARNING
Risk of a fatal electric shock
-
An electric shock can cause injuries in the form of burns and cardiac
arrhythmia, respiratory arrest or cardiac arrest.
• Do not clean the blender under running water. Use only a cloth dampened
with water.
• Disconnect the power supply plug before cleaning the blender.
Pos : 7.3 /00004 War nhi nweis e/H 0006 H INWEIS D efekt von Bauteilen durch Flüssig keitenEindringen von Fl üssig keiten ins Gehäus einne @ 1\mod_1248181032171_9.doc @ 11723 @ @ 1
NOTICE
3.H0006
Defective components due to liquids
Penetration of liquids into the inside of the device
–
Components are damaged and the function of the device is no longer
ensured.
•
Clean the device under running water. Only use a moist cloth
Pos : 7.4 /00004 War nhi nweis e/H 0009 H INWEIS Ger ätesc haden durch Lös ungs mittel @ 0\mod_1231165437212_9.doc @ 5441 @ @ 1
NOTICE
Damage to the machine through solvents
–
Solvents may damage plastic parts and the paint finish.
•
It is not allowed to use solvents.
Pos : 7.5 /00010 Bedienungsanlei tungen Kapitelsamml ung en/PT 200 ( 2011)/0025 PT 200 Rei nigung und Wartung /2505 PT 200 M odul R ei ni gung und Wartung @ 3\mod_1302848179641_9.doc @ 25160 @ @ 1
This device is designed such that all parts coming into contact with material may
be removed easily and without tools.
These parts taken from the device can therefore also be cleaned in a water bath,
under running water and in a dishwasher.
Pos : 8.1 /00005 Übersc hriften/1. Übersc hriften/1 Fehler meldungen @ 2\mod_1259056589728_9.doc @ 17580 @ @ 1
7 Fault messages
Pos : 8.2 /00010 Bedienungsanlei tungen Kapitelsamml ung en/PT 200 ( 2011)/0035 PT 200 Fehler meldung en/3505 PT 200 M odul F ehler meldung @ 3\mod_1302772715593_9.doc @ 24660 @ @ 1
Error code Error
Measure
F1
Motor doesn’t start or is
not running
Press the STOP button; if the error
persists, after-sales service must be
consulted
F3
Speed is too high or too
low
Press the STOP button; after-sales
service must be consulted if the error
persists.
F5
Keypad defective
Service necessary
Pos : 9.1 /00010 Bedienungsanlei tungen Kapitelsamml ung en/------- Seitenumbr uch ----------- @ 0\mod_1222344373758_0.doc @ 2386 @ @ 1