Robustel R3000 User Guide - Manual (Page 57)

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 56 / 131
Confidential
Delay
Available when enable Pulse in Alarm On Action/Alarm Off Action.
The first pulse will be generated after a “Delay”.
Input from 0 to 30000ms. (0=generate pulse without delay)
0
Low
Available when enable Pulse in Alarm On Action/Alarm Off Action.
In Pulse Output mode, the selected digital output channel will generate a square
wave as specified in the pulse mode parameters. The low level widths are specified
here.
Input from 1 to 30000 ms.
10
High
Available when enable Pulse in Alarm On Action/Alarm Off Action.
In Pulse Output mode, the selected digital output channel will generate a square
wave as specified in the pulse mode parameters. The high level widths are
specified here.
Input from 1 to 30000 ms.
10
Output
Available when enable Pulse in Alarm On Action/Alarm Off Action.
The number of pulses, input from 0 to 30000. (0 for continuous pulse output)
0
SMS Content On
Available when enable SMS Control in Alarm Source.
Input the SMS content to enable “Alarm On Action” by SMS (70 ASIC II char max).
Null
SMS Content Off
Available when enable SMS Control in Alarm Source.
Input the SMS content to enable “Alarm Off Action” by SMS. (70 ASIC II char max)
Null
SMS Content On
Reply Input the SMS content, which will be sent after DO was triggered. (70 ASIC II char
max).
Null
SMS Content Off
Reply Input the SMS content, which will be sent after DO was recovered. (70 ASIC II char
max).
Null
Phone Group Click to add phone groups. Null
Note: R3000-4L does not support SMS/Call function, so Call and SMS section will not be displayed on the web page.
3.16 Configuration -> USB
This section allows users to set the USB parameters.
Note: Users can insert an USB storage device, such as U disk and hard disk, into the router’s USB interface. If there is
configuration file or firmware of R3000 inside the USB storage devices, R3000 will automatically update the
configuration file or firmware. We will provide another file to show how to do USB automatic update.
USB
Item Description Default