Schwank STR-CANADA - Manual (Page 13)

SP-MSTR-AC-11A
STR Manual
RD: NOV, 2003
RL: 11
KH
Page 9
FIGURE 12 PLATE HANGER/ELBOW INSTALLATION
1 End-Plate-Hangers
2 Focus Shield Reflectors
3 End-Plate-Hanger Flange OVER
Reflector
4 End Plate Hanger Flange UNDER
5 90 0 (shown) or 180 0 Elbow
6 Tube Couplers
7 “Point at which Swaged Tube is fully
inserted into elbow and Swaged end of
elbow is fully inserted into tube.
FIGURE 11 MOUNTING REFLECTOR TO END PLATE HANGER
8. REFLECTOR INSTALLATION
After burner and tubes have been installed,
slide the focus shield reflectors one at a time,
into the wire hangers. (the end of the first and
last focus shield reflectors must be secured to
the first and last end plate hangers with four
screws each. SEE FIG: 11 and 12 (ABOVE). As each successive focus shield reflector is
installed on an in-line installation, the ends of
the focus shield reflectors will meet at the
centre of the reflector slide and will provide
continuous coverage over the entire tube
system.
1 End-Plate-Hanger Flange
over the Reflector
2 End-Plate-Hanger Flange
under the Reflector
3 Screws securing Reflector
to End-Plate-Hanger
4 Chain Hole for horizontal
suspension
5 Chain Hole for up to 45º
suspension
6 Opening for tube
7 Focus-Shield Reflector
1
2
2
3 3
4
4
5
6
7
6
5
4
7
3
1
2
1
7