SPYPOINT TINY-W2 - Manual (Page 12)

22 23
English
English
Infrared:
(On/One LED/Off)
Allow the user to choose how many LEDs
will be turned on.
On: Every LEDs work when taking photos
or videos at night.
One LED: Only a single LED works (see
figure). This option can be useful when using
an IR-Booster/Black LEDs IR-Booster (sold
separately, refer to the section “OPTIONS”).
Off: LEDs are deactivated so your night
photos or videos are pitched black.
Side Sensors:
(On/Off)
When the side sensors are activated, a total of
7 zones is covered. The central sensor covers
5 zones. The side detectors are mainly used
to prepare the camera so when your target
passes through the central sensor, the system
is already pre triggered, increasing greatly
the reaction time of your camera.
Note: The side sensors require more battery
power.
TINY-W 2
LED for
infrared
sensor
Time Lapse:
(Off/30s/1m/3m/
5m/15m/30m/1h)
Allow the user to set the frequency at which
time the camera takes a picture, without
detection. For example, if the option
“5 minutes” is selected in the “Time Lapse”
mode, the camera takes a picture every 5
minutes during that period of operation (time
start and time stop) even if there is no detection.
This option allows the user to obtain
pictures of game outside the detection range
of the camera.
Note: The “Time Lapse” mode only applies
in “PHOTO” mode, not in “VIDEO” mode.
When “Time Lapse” mode is selected, the
“Delay” mode and the “Multi-shot” mode
are disabled. In addition, the photo
resolution is reduced to 800 x 600 to allow
the possibility of video editing.
26’
(8m)
30’
(9m)
50’
(15m)
30° 70° 40°
6
&
6
Camera
s: side sensors
c: central sensor
Detection distance
(central)
Detection angles
Viewing angle
Detection distance
of the side sensors