SPYPOINT TINY-W2 - Manual (Page 13)

24 25
English
English
REPORT
The report mode keeps a record of the last period of use of
the camera. The beginning date corresponds with the moment
the camera is set to either “Photo” or “Video” mode.
Thus,
the report is reset when changing modes.
1.
2.
3.
4.
5.
6.
7.
8.
9.
1. Beginning and end date of the report
2. Number of photos or videos taken during the day
3. Number of photos or videos taken at night
4. Total of photos or videos taken
5. Current time of the camera
6. Current date of the camera
7. Battery level (1/4 = low, 4/4 = full)
8. Remaining space on the SD card estimated by a
number of photos
9. Used space on the SD card (total number of
files, only includes photos and videos taken by a
SPYPOINT camera)
EXTERNAL TRIGGERING
1/8" input which triggers the taking of photos or videos using
a normally open contact. (Example: using a magnetic door
switch connected to an alarm system).
DOWNLOAD TO A COMPUTER
To transfer or view photos and videos on a PC, you must first
turn off the camera and connect the USB cable (supplied)
from the camera to your computer. The computer will
recognize the camera and will install the software itself.
Click on “My Computer” and select “Removable Disk”.
Then click “DCIM” and “100DSCIM” to find all your photos
and videos.
Taking the SD card out of the camera and inserting it into
the computer port will achieve the same results. If no SD
slot is built into the computer, a multi-card reader RD25-1
(sold separately, refer to the section “OPTIONS”).
To upload or view photos stored in the Blackbox receiver,
proceed the same way using the SD memory card.
Note: The names of the images recorded by the TINY-W 2
camera starts by PICT while those stored in the receiver
starts by PICW .