SPYPOINT TINY-W2 - Manual (Page 5)

8 9
English
English
1. Power button
2. Recording indicator LED
3. “UP” button
4. “BACK” button
5. “OK” button
6. “DOWN” button
7. ALK / RECH (switch for battery)
8. SD card slot
9. USB port
10. 12 volts jack
11. External trigger jack
12. TV OUT
13. Removable battery case
POWER (TINY-W 2 CAMERA)
The battery level is shown in the bottom right corner of the
screen when the camera is in “Test” mode. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
During the installation of alkaline batteries, place the switch
inside the battery case to “
ALK ” (i.e. alkaline). Insert the
batteries in the battery case as indicated and insert it inside
the camera (see figure below). Exact polarity must be
followed. We also recommend the use of new batteries to
ensure maximum performance of your camera.
Connector Connector
Top
Lithium battery pack
The camera can be powered by a rechargeable lithium
battery LIT-09/LIT-C-8 (sold separately, refer to the section
“OPTIONS”). This type of battery is less affected by cold
temperatures and lasts up to 3 times more than an alkaline
battery. During the installation of lithium battery, place
the switch inside the battery case to “
RECH ”. Insert the
battery in the case as indicated and insert it inside the camera
(see figure below)