SPYPOINT TINY-W2s - Manual (Page 10)

18 19
English
English
SETTINGS
To define the options of the camera. To configure the system
in English, hold the button "" until "LANGUAGE" is
highlighted. Press "OK", select "ENGLISH" and confirm
your choice with "OK". The system will change all the
menus to English.
Time Start /
Time Stop: Allow the user to set the period of operation
of the camera. The start and stop time are
the hours during the camera is in action and
records pictures or videos. Example: if the
user selects a start time "7:00 am" and a stop
time "11:00 am", the camera will only detect
for that period of time and will stay inactive
for the remaining hours. Press "OK" and use
"" or "" to adjust the hour.
Press "OK" again to set the minutes. When
the time is properly set, press "OK" once
more to go back to other settings. For an
activation of 24 hours, the same start and stop
time must be entered (example: 00:00 as start
time and 00:00 as stop time. These hours are
the basic configuration of your camera)
Note: The hours can be recorded over a
12 or 24 hours period. Refer to "SETTINGS/
TIME FORMAT" (00:00 means midnight)
Transmission:
(On/Off)
Enables or disables the wireless transmission
of images to the Blackbox receiver.
When the transmission is enabled:
• Only pictures are transmitted to the
receiver, not videos.
• The quality of the photos on the receiver
is reduced to maximize transmission:
8MP = 800 x 600 pixels
5MP = 640 x 480 pixels
3MP = 320 x 240 pixels
• When in "TIME-LAPSE" mode, photos
are sent to the receiver except for the
"30s" setting.
• When the delay setting "10s" is selected,
the time between each detection is
calculated when the transmission
is completed. For example, if the
transmission takes two seconds, the time
between the two detections is 12 seconds.
Delay:
(10s/1m/3m/5m/
10m/15m/30m)
Select the time interval between two photos
or videos.
Additional setting: it is possible to reduce
the delay between detections to 10 seconds
(instead of 1 minute) by using the following
procedure. Note that the battery life will be
affected.