SPYPOINT TINY-W2s - Manual (Page 5)

8 9
English
English
1. Power button
2. Recording indicator LED
3. UP button
4. BACK button
5. OK button
6. DOWN button
7. ALK / RECH (switch for battery)
8. SD card slot
9. USB port
10. 12-volt / Solar panel jack
11. External trigger jack
12. TV OUT
13. Removable battery case
14. Microphone
POWER (TINY-W 2S CAMERA)
The battery level is shown in the bottom right corner of the
screen when the camera is in "TEST" mode. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
During the installation of alkaline batteries, place the switch
inside the battery case to "ALK". Insert the batteries in the
battery case as indicated and insert it inside the camera (see
figure below). Exact polarity must be followed. We also
recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
This camera can be powered by a rechargeable lithium
battery LIT-09/LIT-C-8 (sold separately, see OPTIONS).
This type of battery is less affected by cold temperatures
and lasts up to 3 times more than alkaline batteries.
During the installation of lithium battery, place the switch
inside the battery case to "RECH". Insert the battery
in the case as indicated and insert it inside the camera
(see figure below)
Connectors
P INT SPY TM INT P SPY
Top Top
6 x AA Lithium battery pack (LIT-09)