SPYPOINT TINY-W2s - Manual (Page 6)

10 11
English
English
TO INSERT THE BATTERY CASE INSIDE THE CAMERA
External (12V)
This camera can be powered from an external 12-volt DC
input such as a 12-volt battery (KIT-12V/BATT-12V, sold
separately) or a 12-volt adapter (AD-12V, sold separately).
When using a 12-volt input, we recommend you to remove
the alkaline batteries to prevent surcharges. During the
installation of 12-volt battery, place the switch inside the
battery case to "ALK". If combined with a lithium battery
pack, slide the switch to "RECH". To find the accessories
available for the 12-volt, see "OPTIONS".
TINY-W 2s
P INT SPY TM INT P SPY
Connector Connector
Solar panel
This camera also offers the possibility of a connection to a
solar panel SP-12V (sold separately, see "OPTIONS") to
maintain the charge of the lithium battery (sold separately,
see "OPTIONS") or the 12-volt battery (sold separately, see
"OPTIONS"). During the installation of the rechargeable
lithium battery or 12-volt battery, slide the switch inside the
battery case to "RECH" to activate the charging system of
the solar panel.
POWER (BLACKBOX RECEIVER)
It is possible to know the battery level of the receiver when it
is turned on. The TEST LIGHT stays on for 8 seconds when
the batteries are full. When the TEST LIGHT flashes for 8
seconds, the batteries are low and need to be replaced. If
the TEST LIGHT remains off, the batteries are completely
empty or are possibly installed in the wrong direction.
AA batteries
The receiver requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
Insert the batteries as indicated. Exact polarity must be
followed. We also recommend the use of new batteries to
ensure maximum performance of the receiver.