SPYPOINT TINY-W2s - Manual (Page 8)

14 15
English
English
PROGRAMMING
Turn on the camera to navigate in the interface by pressing
"" or "" and press "OK" for selection. To modify the
selection, press "" and "" again and press "OK" to
confirm. To return to the previous menu press "".
PHOTO
To take pictures. The "PHOTO" mode must be selected by
pressing "OK"; the test light in the front of the camera will
blink for 60 seconds to allow the operator to walk away from
the camera.
VIDEO
To take videos. The "VIDEO" mode must be selected by
pressing "OK"; the test light in the front of the camera will
blink for 60 seconds to allow the operator to walk away from
the camera.
TEST
To set the camera or the distance. When "TEST" mode
is selected, no picture or video is recorded. Walk
perpendicularly in front of the camera. When the camera
detects movement, the light blinks to indicate that normally,
a photo or video would have been recorded. If the system
does not detect the movement, increase the distance detection
using the SETTINGS menu (the option "SENSITIVITY"
allows the user to set the sensitivity to "HIGH", "MEDIUM
"or "LOW"). You can also realign the camera differently.
Once you understand how the device responds to detections,
you can better adjust the direction or the height of the camera
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
In "TEST" mode, it is possible to take a picture by
pressing the "OK" button. The photo is saved and
appears in "VIEW" mode.
TINY-W 2s
Test Light