SPYPOINT TINY-W2s - Manual (Page 13)

24 25
English
English
Side Sensors:
(On/Off)
When the side sensors are activated, a total
of 7 zones are covered. The central sensor
covers 5 zones. The side detectors are mainly
used to prepare the camera so when your
target passes through the central sensor, the
system is already pre triggered, increasing
greatly the reaction time of your camera.
Note: The side sensors require more battery
power.
Time Lapse:
(Off/30s/1m/3m/
5m/15m/30m/1h)
Allow the user to set the frequency at which
time the camera takes a picture, without
detection. For example, if the option
"5 minutes" is selected in the "TIME LAPSE"
mode, the camera takes a picture every 5
minutes during that period of operation (time
start and time stop) even if there is no detection.
This option allows the user to obtain
pictures of game outside the detection range
of the camera.
Note: The "TIME LAPSE" mode only
applies in "PHOTO" mode, not in "VIDEO"
mode. When "TIME LAPSE" mode is
selected, the "DELAY" mode and the
"MULTI-SHOT "mode are disabled. In
addition, the photo resolution is reduced to
800 x 600 to allow the possibility of video
editing.
REPORT
The report mode keeps a record of the last period of use
of the camera. The beginning date corresponds with the
moment the camera is set to either "PHOTO" or "VIDEO"
mode. Thus, the report is reset when changing modes.
26’
(8m)
30’
(9m)
50’
(15m)
30° 70° 40°
6
&
6
Camera
s: side sensors
c: central sensor
Detection distance
(central)
Detection angles
Viewing angle
Detection distance
of the side sensors