Regency Excalibur EX90 Large Wood Fireplace (US Edition) - Manual (Page 22)

FPI FP90 Wood Fireplace 22
INST
ALLA
TION
installation
fan installation
05/12/11 918-437
FP90
FAN INSTALLATION
NOTE: If optional Ashtray is installed, it must be removed before installing the fan.
The receptacle Box must be replaced with one that will accept the fan cable.
1) Remove the thumb screw from the fan transfer tray.
2) Slide fan transfer tray fully out through the bottom louver opening.
3) Mount the fan bracket onto the fan transfer tray using the two locating pins (see Diagram 1).
4) Slide the Control Switch Box onto the Control Switch Box Mounting Bracket located on the front of the fan transfer tray and
secure with the #8 x 3/8” screw provided (refer to Diagram 1).
5) Secure wiring to fan tray with supplied strain reliefs.
See Diagram 3.
6) Secure both ground wires to ground lug. Bolt onto unit.
7) Plug fan into receptacle box (see note at
top of page).
8) Slide thermodisc into position
(which is located under the fi rebox).
9) Reinstall the thumb screw.
Diagram 4
Diagram 3
Thermodisc
Strain Reliefs
F F
THERMODISC
M M
FAN
M F
M
F
SWITCH CONTROL BOX
HI
OFF
LOW
GROUND
POWER CORD
WHIT
E
BLACK RED
GREY
WHIT
E
BLUE
M
F
GREY
GREEN
BROWN
GROUND
GREEN
Diagram 2
Diagram 1
Fan transfer tray
Thumb Screw
Control Box
mounting bracket
Control
Box
Locating Pins