Barco R9002031 - Manual (Page 36)

Messages, warnings and failure codes
9-1 5975607 BARCODATA 808s 120397
9
MESSAGES, WARNINGS AND FAILURE CODES
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
Announcement of the selected
source.
enter
password
xxxx
Message to enter your password.
Password contains 4 digits.
text on
text off
These messages will be
displayed on the screen when
pushing the <TEXT> key.
Text ON : the 'Bar scale
indication' will be enabled during
the change of an analog control
in the 'Operational mode'. All
warning and failure messages
will be displayed.
Text OFF : the 'Bar scale
indication' will be disabled
during the change of an analog
control in the 'Operational mode'.
All warning and failure massages
will not be displayed.
PROJECTOR
ADDRESS :
003
WARNING :
input not
available
When using the projector with
the RCVDS, this warning will be
displayed when selecting an
input slot of an RCVDS where
the input board is missing.
When selecting a new source,
information about this source will
be displayed on the screen.
Source number, horizontal and
vertical frequencies of the
displayed source.
WARNING :
source not
available
The input is a valid input but the
source is not connected to the
input terminals or the input source
is switched off.
WARNING :
invalid
key entry
When a wrong key is pressed on
the RCU.
WARNING :
invalid
code entry
Message when the entered
password is wrong.
WARNING :
end of ad-
just range
End of adjustment range.
WARNING :
input no
longer
available
Message will be displayed when
the input source is no longer
available. The following message
then appears: 'check input
signal or select new source'.
This message will be displayed
after the message 'input no longer
available'. It asks to check the
connections between the source
and the projector or to check if
the source is switched on.
check input signal
or select
new source
WARNING :
input selector
not
available
It warns you to check the power
connection or the power status
of the RCVDS.
Next message will appear
immediately on the screen : 'go
to standby'.
Indication of the projector
address when activating the
'ADDRESS' button on the RCU
with a pencil or other small
object.