Vicor PI33XX-2X I2C Digital Interface Guide - Manual (Page 5)

vicorpower.com Rev 1.0 Cool-Power
®
800 735.6200 11/2012 Page 5 of 22
PI33XX-2X I
2
C Digital Interface Guide
Figure 4 - LinkM Detection Followed by Picor Buck GUI Main Screen
After the user observes a successful main screen like the one shown in Figure 4 and the LinkM is installed to the
target board as shown in Figure 1, it is possible to use the Picor Buck GUI to monitor and configure the PI33XX-2X.
The target PI33XX-2X unit should be powered on using the proper input voltage value and enabled by the user.
Failure to apply input voltage will result in the error message shown in Figure 28 (see Picor Buck GUI Error
Messages Section) upon pressing any of the “soft” buttons on the screen. The LinkM should not be removed or