Vigo VG06061 - Manual (Page 10)

10
MODEL VG06061
FIG.7 SEAL STRIP INSTALLATION DIAGRAM
13
10
THIS SIDE MUST
LOOK INSIDE THE
CABIN
MAGNET
3/8"
[10mm]
5
10
15
13
14
13
D. INSTALLING THE WATER SEAL STRIP TO DOOR PANEL
1. Clean the door glass panel (#13) edge where the door side seal strip (#14) is to be installed with rubbing
alcohol.
2. [SEE FIG.7]
3. Verify that the soft flange of the seal strip faces toward the inside of the shower cabin before seal strip
installation.
4. Install the seal strip according to the diagram. See Note: A. Leave the extra top of the seal strip that is
overlapping the glass and cut at finish of install.
10
4
5
13
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
NOTES:
1. If the seal strip is not flat or twisted, use hot water and a hair dryer to apply minimal heat and press the seal
strip back into position.
2. Part #14 is reversible and pre-cut on top and bottom to fit in proper configuration. Cutting/finishing is needed
but only after fully installing and only at the top of the unit.
3. The door magnetic seal strip (#10) and the side seal strips (#6) will be 10mm shorter than the side glass panel.
This is to compensate for the depth of the bottom rail. The door magnetic seal strip (#10) is reversible and will
need to be cut at top for best aesthetic approach.
10
THIS SIDE MUST
LOOK INSIDE THE
CABIN
4
14
NOTE: A
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
14
3/8"
[10mm]
15
6
5
4
6