Vigo VG06061 User Manual
Page 13
13
MODEL VG06061
2
1
3
16
G.
INSTALLING THE SIDE & FRONT PANEL SUPPORT
1.
Install the support assembly (#3) onto the side glass panel (#4) approximately two-thirds
away from the wall. Use hex key to tighten to screws. [SEE FIG.11]
2.
Install the support assembly to the structural arm (#2) and wall connector (#1). Make sure it's
level.
3.
Mark the holes on the wall for the mounting screws for the wall connector.
4.
Remove the support assembly. Drill holes into respective marks and put plastic anchors (#19)
in them. Not necessary if installing into studs.
5.
Replace wall connector to proper position. Screw it in to the wall with 1 1/8" screws (#16).
6.
Slide the structural arm (#2) into the wall connector (#1). Tighten all set screws.
7.
Repeat Steps 1 through 6 to install the other support assembly to the other side glass panel.
19
!
FIG.11
WALL
WALL
SIDE PANEL
LEVEL