Vigo VG06061 User Manual
Page 12
F. INSTALLING SIDE GLASS PANEL (PART #5)
1.
Install the side seal strip (#6) to the wall side of the side glass panel (#5). Install the magnetic
side seal strip (#10) to the door side.
The magnetic side should be facing the outside and
the clear side be facing the inside. Be sure to place the seal strip (#6) 10mm from the
bottom of the glass. [SEE FIG.9] Installing the magnetic seal strip prior to locating the place
for the glass support allows for proper seal. You may need to adjust the magnetic seal strip
placement after full install to guarantee proper placement on the top of the corner joint. It
should rest tight on the corner joint in order to prevent water leakage.
2.
Screw in the glass support (#7) to the side glass panel using the hex key (supplied) making
sure to slide it back as far as possible from the glass before you tighten. Be sure to use
washers on both sides of the panel.
3.
Place the side glass panel into the bottom rail (#9). Use the level to position the side glass
panel correctly. Making sure the seal strip is against the wall.
4. Mark holes on the wall for the mounting screws.
5. Remove the side glass panel. Drill holes into respective marks and insert plastic anchors
(#20) inside them. Not necessary if installing into studs. Studs are the preferred means of
installation, anchors can pull out of the wall causing property damage and bodily harm.
6. Replace the front glass panel back onto the bottom rail and screw it to the wall with 1 5/8"
screws (#17).
FIG.9
THIN
GASKETS
6
7
WALL
SIDE
DOOR
SIDE
20
17
5
GLASS SUPPORT (7)
GASKET
SIDE GLASS PANEL (5)
HEX SCREW
VIEW FROM THE TOP
WALL
FIG.10
HEX SCREW (17)
10
3/8"
[10mm]
5
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
!
5
5
6
6
7
7
17
12
MODEL VG06061
9