Vigo VG06061 User Manual
Page 11
11
MODEL VG06061
HEX SCREW
SIDE GLASS
PANEL (4)
DOOR (13)
THIN
GASKET
VIEW FROM THE TOP
HINGE (8)
OUTSIDE OF
THE CABIN
INSIDE OF
THE CABIN
PLATE
E. INSTALLING THE DOOR
1.
Make sure you have the door right side up. The distance at the top is slightly larger than the
distance at the bottom. [SEE FIG.8]
2.
Clean the door (#13) glass surfaces where the hinges (#8) are to be installed with rubbing
alcohol.
3.
Place magnetic seal strip (#10) to the panel. The magnetic side should be facing the inside
and the clear side be facing the outside. Make sure the seal is level with the bottom of the
panel. Do not install the handle first, this is dangerous and may cause the glass to break.
Install the top hinge first for safety and ease of install.
4.
Position the door onto the hinges. Hold securely in place using shims. The seal (#14) may get
stuck between the two panels of glass. Pull the seal out of the groove using your fingers and
nothing sharp, making sure not to damage the seal. Tighten allen key screws.
5.
Install the hinges as illustrated [SEE FIG.8A] Use the hex key supplied.
6.
Adjust hinge so the gaps are equal at top and bottom and pull door panel away from side
panel to allow the door to swing freely without crimping seal strip (#14).
7.
Lift door panel to be level with hinge panel. Use PVC shims provided to hold firmly in place.
WARNING
!
DOOR PANEL INSTALLATION REQUIRES TWO OR MORE PEOPLE TO ASSIST
THIN
GASKETS
THIN
GASKET
SEAL STRIP (14)
10
!
VIEW FROM INSIDE
FIG.8A
FIG.8
9 7/8"
[250mm]
8 3/4"
[223mm]
DOOR
NOTE - You may need to add more than one shim per hinge as glass hole openings vary during
production. PVC shims prevent the door from sagging due to gravity and the
weight of the door. Never install without shims, this can cause the glass to break causing
property damage and bodily harm.
TOP
BOTTOM