Vigo VG06061 - Manual (Page 9)

9
MODEL VG06061
WALL
SIDE
C. INSTALLING SIDE GLASS PANEL (PART #4)
1. Arrange glass to the preferred configuration. (see diagram on page 5) These instructions
are for a right side door opening configuration.
2. Select the door opening location on the shower cabin.
3. Install the side seal strip (#6) to the wall side of the hinged side glass panel (#4). [SEE FIG.5]
4. Screw in the glass support (#7) to the side glass panel using the hex key (supplied) making
sure to slide it back as far as possible from the glass before you tighten. The part that
connects to the wall should face in. [SEE FIG.6] Be sure to use gaskets on both sides of the
panel. The glass holes are elliptical allowing for 5mm out of square.
If your shower stall is out of square more than 5mm from the top of the glass to
the bottom of the glass then this can cause the shower to potentially leak and can
cause potential fatal harm.
5. Make sure glass panel is level to the wall. Be sure to install the correct glass with the correct
rail. [SEE FIG.1A]
6. Place the side glass panel onto the bottom rail (#9). Use the level to position the side glass
panel correctly. Make sure the seal strip is against the wall.
7. Mark holes on the wall for the mounting screws.
8. Remove the side glass panel. Drill holes into respective marks and insert plastic anchors
(#20) inside them. Not necessary if installing into studs. Studs are the preferred means of
installation, anchors can pull out of the wall causing property damage and bodily harm.
9. Replace the front glass panel back onto the bottom rail and screw it to the wall with 1 5/8"
screws (#17).
!
!
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
FIG.5
THIN
GASKETS
6
7
20
17
4
GLASS SUPPORT (7)
GASKET
SIDE GLASS PANEL
HEX SCREW
VIEW FROM THE TOP
WALL
FIG.6
SCREW (17)
OUTSIDE OF SHOWER INSIDE OF SHOWER