Waldmann PULSE HFMD version VFC III - with MFT - Manual (Page 18)

18
GB Operating Manual Light control “PULSE HFMD - Vers. III“ GB Operating Manual Light control “PULSE HFMD - Vers. III“
Explanation of the functions (part 3)
Function 7
Reduced sensitivity
Function to change the sensitivity
of the presence control.
The default setting of the function
is “OFF“, i.e., the presence sensor
has its normal sensitivity (100%).
Small movements are also detec-
ted within the detection range of
the sensor.
The presence sensor works with
reduced sensitivity (approx. 50%)
if the function is set to “ON”. Small
movements within the detection
range of the sensor are not detec-
ted anymore.
The function can be changed on
lights with sensors XXX /P
Function 8
Switch-on automatic
Function to admit or to suppress
automatic switch-on with insuffi -
cient light or in case of presence
(semi-automatic).
The default setting of this function
is “ON“, i.e., the light is automatical-
ly switched on in case of presence
or insuffi cient light.
The light has to be switched on
manually even in case presence
was detected if the switch-on
automatic is inactive.
The function can be changed on
lights with sensors XXX /P
Function 9
Special function
The special function is not avai-
lable.
The function cannot be changed.
Fig. 3
Key I
Logo
Light
bar
Key II
LED I
LED II
Note: The functions written in red
are not active.