To restore saved configuration settings, Click open, Click general restore or full restore – Western Digital WD ShareSpace User Manual User Manual
Page 124: Click ok, To restore the device to factory defaults
NETWORK STORAGE MANAGER: ADVANCED MODE - 119
WD SHARESPACE
USER MANUAL
To restore saved configuration settings:
1. On the Configuration page, click Browse.
2. Select the previously saved system configuration file.
3. Click Open.
WARNING! Before you restore configuration settings, bear in mind that
all current system configurations and user data are lost when you do a
Full Restore. When you do a General Restore, all current system
configurations are lost, but your data is not deleted.
4. Click General Restore or Full Restore.
General Restore restores all features to previously saved settings. The data
volume and shares settings are not changed.
Full Restore restores all features, including the data volume and shares, to
previously saved settings. All data files are erased from the drive.
5. Click OK.
To restore the device to factory defaults:
Important: Save the current configuration prior to restoring the factory
default settings.
Performing a factory default reset will erase all settings in the WD ShareSpace.
System configuration will reset the device to default factory settings. All
information and data will be lost. The LAN settings (including port settings) are
not changed. After the reset, the administrator login/password will be changed to
“admin/admin.”
1. On the Configuration page, click Restore Factory Default.
2. Click OK.
During the system restore process, the system will turn off the power LED and
blink the backup LED. Wait until the system restore process is completed.
Note: You cannot access the configuration web pages if you forget the administrator password, IP
address setting, or device name. Use the reset button to restore these settings (including IP setting,
device name, and administrator password) to factory default configuration. To use this function,
press and hold the reset button on the back of the device (next to power interface) for at least 10
seconds. The system reboots automatically and you can then use the default settings to access the
device.