Yamato Scientific HC200 Cool Block - Manual (Page 46)

44
Indication after Step/Step Procedure Explanation
Setting an End Segment
32.
•
Once the controller accepts the parameters of
segment 4, it is ready for input of segment 5.
33. Push the ENTER key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The sub display shows requesting for input
of Ramp Time 5.
! Push either ▼ key or ▲ key, push ENTER key to
set the controller on the end segment input mode.
34. Push ENTER key after selecting ON or OFF
by ▼ key or ▲ key.
•
Push either ▼ key or ▲ key to flash on the
main display.
⇒ ⇒ ⇒ ⇒ The controller turns to the end segment input mode.
35. Push the ENTER key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing ENTER key accepts the end segment and
completes setting all the parameters of Program 3.
⇒ ⇒ ⇒ ⇒ The displays return to the screens of the program
input mode.
(Ex. The number of unused segments)
(The program number
that you are working on.)
(Ramp time of segment 5)
(Ex. The number of unused segments)
(Ex. The number of
the used segment 5)