3D Robotics Aero-M User Manual
Page 25
24
Wings
Attach a wing onto each side of the spar. Do not twist the wing
or the spar so as not to stress the foam.
Locate the two cables inside the electronics compartment marked AILE. Connect these
cables to the two cables on the wings marked AILE. (Either of the wing cables can
connect to either of the plane cables; the order doesn’t matter.)
Place the wings over the body of the Aero with the foam
squares fitted into the matching space in the electronics
compartment. Make sure not to pinch the AILE cables.
Locate the four large rubber bands. Use the bands to
secure the wings to the body of the Aero by the four
orange knobs on the body around the wings.
Attach two of the bands to the two knobs on one of the
short sides and opposite knobs on the opposing side.
Repeat on the other short side with the remain-
ing two rubber bands, resulting in two pairs of
opposing right triangles.
1
2
3
4