3D Robotics Aero-M - Manual (Page 5)

4
1
Turn on the controller. To avoid triggering
the controller’s startup alarm, ensure that
all switches are set back (away from you)
and the throttle stick is set fully down.
!
It is important to establish communication before
powering on the Aero. Always turn on the controller
before connecting the battery. When powering off
the Aero, disconnect the battery before turning off
the controller.
3
Insert a charged battery into the battery slot,
and attach the yellow connectors. This will
power on the Aero.
Hold the Aero still and level while it powers on.
Attach the velcro above the battery slot to the
velcro on the battery. Close and secure the lid
onto the battery compartment.
!
2
Open the battery compartment by
sliding the knob on the orange switch
forward and lifting out the lid.
Powering the Aero
RC controller
Throttle stick
Switches
Aero: battery compartment lid
battery slot
battery
connector
Aero: battery compartment interior
flight battery