Rockwell Automation 20D Stegmann Feedback Option Board for PowerFlex 700S Drives - Manual (Page 12)

12 Stegmann Feedback Option Board for PowerFlex® 700S Drives
Step 7: Wire the Stegmann
Feedback Option Board to
an Encoder Terminal block P1 contains connection points for a Stegmann Hiperface®
encoder. This terminal block resides on the Hi-Resolution Encoder
Feedback Option board.
Hiperface® is a registered trademark of Stegmann Inc.
TIP: Remember to route wires through the sliding access
panel at the bottom of the Control Assembly.
Terminal Signal Description
12 POWER COMMON Power supply for encoder
interface. 11 POWER
10 REFSIN Negative Sine signal.
9 +SIN Positive Sine signal.
8 REFCOS Negative Cosine signal.
7 +COS Positive Cosine signal.
6 SHIELD Connection point for encoder
cable shield.
5 SHIELD
4 N/C Not connected.
3 N/C
2 DATA+ (RS 485) Positive DH485 terminal.
1 DATA- (RS 485) Negative DH485 terminal.
12
34
56
78
9
1
0
1
1
1
2