Rockwell Automation 20P PowerFlex DC Drive - Frame D Field SCR Module - Manual

Publication 20P-IN055A-EN-P
PowerFlex® DC Drive
Frame D Field SCR Module
Installation Instructions
What This Kit Includes
•
Field SCR module
•
Gate lead cables (2)
•
Screws and washers (2)
•
Thermal grease
•
Static strap
Important: It is highly recommended that the field circuit board and field dual
diode module be replaced when replacing the field SCR module.
The field circuit board and field dual diode module are sold as
separate spare part kits.
Tools That You Need
•
Phillips
®
screwdriver
•
Hexalobular screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.