Rockwell Automation 20P PowerFlex DC Drive - Frame D Field SCR Module - Manual (Page 3)

3
Publication 20P-IN055A-EN-P
Important: A communication cable connects the HIM assembly to the
Control board mounted on the control pan. Therefore, the
bottom control pan cover and HIM assembly cannot be fully
removed from the drive until the cable is disconnected. Step 4
details this connection.
3. Loosen, but do not remove, the four hexalobular screws that secure the
bottom control pan cover to the drive, then slide the cover up and off the
drive chassis (see
Figure 1 below). Tightening torque is noted in the
illustration for reassembly.
Figure 1 Cover Removal
Disconnect
DPI cable
=
Top control
pan cover
Bottom control
pan cover
Tightening torque:
1.5 N•m (13 lb•in)
T15