Rockwell Automation 20P PowerFlex DC Drive - Frame C Switching Power Supply Circuit Board Fuses - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C Switching
Power Supply Circuit Board Fuse Replacement
What This Kit Includes
•
Two Fuses:
– Frame C drives with Switching Power Supply circuit board, SW3-32,
rev. H & below, one 5x20mm, 2.5A 250V fuse and one 5x20mm,
3.15A 250V fuse
– Frame C drives with Switching Power Supply circuit board, SW3-32,
rev. I & above, two 5x20mm, 2.5A 250V fuses
•
Two fuse holder caps
What You Need to Do 1. Remove and lock-out all incoming power to the drive.
2. Disconnect the DPI cable from the HIM assembly (if present).
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
L1 L2 L3
O
I