Rockwell Automation 20P PowerFlex DC Drive - Frame C Switching Power Supply Circuit Board Fuses - Manual (Page 2)

2 PowerFlex® DC Drive - Frame C Switching Power Supply Circuit Board Fuse Replacement
3. Loosen, but do not remove, the screws that secure the bottom cover to
the drive, then slide the cover down and off the drive chassis.
4. Loosen, but do not remove, the screws that secure the top cover to the
drive, then slide the cover up and off the drive chassis.
Important: The HIM assembly is connected via a cable to the Control
board and therefore will not pull free from the drive until
disconnected. See step 4 below for instructions.
STS
PORT
MOD
NET A
NET B
=
Disconnect
DPI cable
Tightening torque:
1.5 N•m (13.3 lb•in)
STS
PORT
MOD
NET A
NET B
FU1 FV1
U V
C D
W
Tightening torque:
1.5 N•m (13.3 lb•in)