BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 48)

Rev. 3.02 - 48 -
SRP-270
8. Appendix (Spec of SMP-710/710N)
8-1 Specifications
8-1-1 Printing specifications
Item
Description
Printing method serial impart dot-matrix
Head wire configuration 9-pin serial type
Dot pitch 0.352mm(1/72")
Dot wire diameter 0.3mm(0.01")
Printing direction Bidirectional with logic seeking
Printing width 63.5mm(2.5")
Line feed 4.233mm(1/6") (default setting)
Paper feed method Friction feed
Paper feed speed Approximately 6.2 inches/second (during continuous paper feeding)
Characters per line See the table on the next page
Characters per inch See the table on the next page
Total dot count
(horizontal direction) 7×9 font (400 half-dot positions per line)
9×9 font (400 half-dot positions per line)
Print speed
Approximately 4.6 lines/second (40 columns, 16cpi)
Approximately 8.4 lines/second (16 columns, 16cpi)
NOTE: If the print duty ratio is too high, the operation of the print ※ head is stopped by the duty limit.
In such circumstances, the print speeds shown above cannot be guaranteed.
cpi=characters per inch.