BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 82)

Rev. 3.02 - 82 -
SRP-270
8-8-2-5 Main assembling - #2
Name of Parts Method and Procedure
① GEAR REDUCTION A
② GEAR REDUCTION B
③ RIBBON FEEDER ASSY
④ GEAR REDUCTION “C”
⑤ LEVER RIBBON FEED ASSY
⑥ WASHER (ø 2.6*5*0.5, 2EA)
⑦ MAIN PCB ASSY
⑧ FPC CONNECTOR
⑨ SCREW MACHINE (M3*4)
⑩ CARRIAGE HEAD ASSY
⑪ BELT SYNCHRONUOS
⑫ SPRING LEVER TENSION BELT
1. Set FRAME MAIN on the JIG.
2. Set ①GEAR REDUCTION A, GEAR REDUCTION B
② ,
RIBBON FEEDER ASSY ③ and GEAR REDUCTION "C" ④
onto SHAFT sequentially. Grease teeth and upper face of
RIBBON FEED ASSY.
3. Insert LEVER RIBBON FEED ASSY ⑤ and WASHER ⑥ .
4. Attach FPC CONNECTOR to ⑧ MAIN PCB A ⑦ SSY. Next,
plug SOLENOID WIRE (block) in connecter 2p. And then, set
it to M/F and tighten two SCREW MACHINE
⑨ .
5. Insert BELT SYNCHRONUOS into ⑪ CARRIAGE HEAD ⑩
ASSY, and then, belt up round PULLEY and GEAR PULLEY.
6. Hoot SPRING LEVER TENSION BELT ⑫ .
<Check Point>
Check the tear of FPC.