BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 84)

Rev. 3.02 - 84 -
SRP-270
8-8-2-8 Main assembling - #5
Name of Parts Method and Procedure
① RIBBON FRAME
② SPRING RIBBON FRAME
③ E-RING (ø3, 3EA)
1. Insert ⓐSPRING RIBBON FRAME into the hole in left side of
ⓑ RIBBON FRAME to ward arrow on shows in Fig. 1 detail.
2. Set SPRING RIBBON FRAME ⓐ onto the SHAFT ⓒ and then, move
the RIBBON FRAME toward arrow.
3. Next, insert RIBBON FRAME onto SHAFT ⓓ toward arrow an shows in
Fig. 3.
4. And then, insert the other hole A of RIBBON FRAME onto SHAFT ⓒ
and then, adjust the position of RIBBON FRAME to the center as
shows in Fig. 4.
5. Firs t E-RING to SHAFT ⓒ and two E-RING to SHAFT ⓓ .
6. Check RIBBON FRAME to move smoothly as operating it up and
down.
a