BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 75)

Rev. 3.02 - 75 -
SRP-270
8-8-1 Sub-assemblies
8-8-1-1 Carriage Head Assy
Name of Parts Method and Procedure Drawings
BE ① RIN G FE (2ea)
CARRIAGE HEAD ②
1. At first, set the BERIN G FE ①
to be inserted into the shaft of JIG.
* Notice: The direction of insert
is to locate frange downward.
2. And then, set a CARRIAGE HEAD ②
to be inserted into the shaft of JIG.
3. Next , set other BERIN G FE ① to be
inserted into the shaft of JIG.
* Notice: The direction of insert is to
locate frange upward.
4. Lastly, insert two BERIN G FE ① in
the CARRIAGE HEAD ② by pushing
the handler of Lever Press.
< Check Point>
Check improper insertion of BERIN
①
G FE and fraction of CARRIAGE ②
HEAD.
8-8-1-2 Lever Ribbon Feed Assy
Name of Parts Method and Procedure Drawings
SHAFT REDUCTION ①
“B”
LEVER RIBON FEED
②
GEAR REDUCTION ③
“B”
WAVE WASHER
④
E ⑤ -RING (ø2.5)
1. At first, Grease SHAFT on the ① ②
LEVER RIBBON FEED with HG-
31S.
2. And then, Assemble ④WAVE
WASHER and Grease WAVE ④
WASHER.
3. Last, assemble GEAR ③
REDUCTION “B” and E ⑤ -RING
(ø2.5).
8-8-1-3 Ribbon Feeder Assy
Name of Parts Method and Procedure Drawings
SPRING RIBBON ①
FEEDER
RIBBON FEEDER
②
GEAR R ③ IBBON
FEEDER
1. Grease SPRING RIBBON ①
FEEDER with HG-31S and insert
that into RIBBON FEEDER.
②
2. And then, insert GEAR RIBBON ③
FEEDER to fit the section of hook.