BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 81)

Rev. 3.02 - 81 -
SRP-270
8-8-2-4 Main assembling - #1
Name of Parts Method and Procedure
① FRAME MAIN C/K ASSY-4
② SERIAL NO. TAG
③ TAPE INSULATION
④ LEVER COLOR CHANGE
⑤ SOLENOID ASSY
⑥ SPRING SOLENOID
⑦ SCREW MACHINE (M2*3)
⑧ GEAR PULLEY ASSY
WASHER (ø2.6*5*0.5)
⑨
LEVER TENTION BELT ASSY ⑩
SCREW (M3*4) ⑪
1. Set FRAME MAIN C/K ASSY ① -4 on the JIG.
2. Paste SERIAL NO. TAG in the right side and TAPE ② ③
INSULATION on the bending line in the bottom face.
3. Grease SHAFT(6 point) with HG-31S.
4. Insert LEVER COLOR CHANGE
④ into SHAFT in the left
bottom side and fit WASHER(2.6*8*0.5).
5. Turn SOLENOID ASSY ⑤ and SPRING SOLENOID ⑥
downward and insert it into the hole of LEVER C/C and M/F
side step by step. Next, tighten ⑦SCREW MACHINE.
6. Insert GEAR ⑧ PULLEY ASSY and then, fit WASHER ⑨ .
7. Insert LEVER TENTION BELT ASSY ⑩ to the hole and then,
tighten SCREW ⑪ two-third.