BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 77)

Rev. 3.02 - 77 -
SRP-270
8-8-1-7 Bracket PF “R” Assy
Name of Parts Method and Procedure Drawings
① BRACKET P/F “R”
② GEAR PF IDLE
③ GEAR KNOB
④ GEAR KNOB IDLE
⑤ WASHER (1.6*3*0.3)
1. At first, grease the small shaft of
BRACKET P/F “R” with EM ① -501.
Next, insert GEAR PF IDLE, ②
GEAR KNOB, and GEAR ③ ④
KNOB IDLE. Lastly, assemble
WASHER. ⑤
2. Grease the outer diameter of gear
with EM-501.
<Check Point>
Check GEAR KNOB to rotate
③
smoothly.
8-8-1-8 Platen Assy
Name of Parts Method and Procedure Drawings
① PLATEN PLATE
② TAPE D/F
③ PLATEN
1. Paste the TAPE D/F onto the ②
PLATEN PLATE and set the sub ①
Assy into the rectangular hole of the
exclusive JIG.
2. Set the PLATEN to fit the groove ③
of JIG and paste by pushing.